Need help?Do you have a question about the SIATA Aqua Timer Plus and is the answer not in the manual?
General| Model | Aqua Timer Plus |
|---|---|
| Category | Controller |
| Manual Watering | Yes |
| Display | LCD |
| Watering Duration | 1 minute to 240 minutes |
| Watering Frequency | Every 6, 12 hours or from 1 to 7 days |
| Rain Delay | Yes |
Details on how to package and store the Aqua Timer Plus unit to maintain its condition.
Instructions for the correct physical installation of the Aqua Timer Plus controller.
Guide to connecting the Aqua Timer Plus controller to power and other components.
Information on built-in protection mechanisms against overloads and disturbances.
Procedure for powering on the Aqua Timer Plus controller.
Guide to setting up the different operational modes and configurations for the controller.
Configuration for a single column system that starts regeneration based on time.
Configuration for a single column system that starts regeneration based on water volume treated.
Configuration for a single column system using a combination of time and volume for regeneration.
Configuration for a duplex system starting regeneration based on time.
Configuration for a duplex system starting regeneration based on water volume.
Configuration for a duplex system using mixed time and volume for regeneration.
Details on accessing and using specific codes for programming the controller's functions.
Setting up the reserve volume for water treatment capacity.
Enabling and using the remote start functionality for regeneration cycles.
Configuring the ratio between impulses from the litre counter and water volume.
Method for calculating the total treatable water volume of the system.
Explains regeneration cycle types and how flags control them, including stand-by.
Setting up and managing alarms for low salt levels and remaining regenerations.
Steps and important considerations for the initial setup and activation of the controller.
Detailed information on electrical connections for various components and distributors.
Controlling the regeneration cycle using an inhibit signal and the OdL flag.
Troubleshooting steps for when the Aqua Timer Plus unit fails to power on.
Troubleshooting guide for persistent motor operation in distributors.
Checking power supply and wiring when users do not receive current.
Steps to diagnose and resolve irregular operating behavior of the Aqua Timer Plus.
To Next Page
