SIATA Aqua Timer Plus User Manual

Aqua Timer Plus - 15/34
6.2.3.b – Programming of the FLAGs
Tab. 13 is to be used in the programming of the flags for the modality LLL1 – LL–3
Tab. 13 – Selection of the operative modality single column - start in mixed mode

FLAG
Display
Operative state / Data visualised
Program
S C - -
State of access to the selection of the programming codes
Advance
S C 0 9
With the key Advance the programming code is increased up to 9
Program
L L L 1
Single column modality. If necessary modify the data with Advance
Program
L L - 3
Mixed regeneration. If necessary modify the data with Advance.
Program
0 H L
0 H L 0
FLAG not used
Program
1 H L
1 H L 0
Interval between two regenerations expressed in days. See par. 6.3.2
Advance
1 H L
1 H L 1
Regeneration to be carried out on the days of the week programmed.
Program
2 H L
2 H L 0
Immediate start of the regeneration at the command of the remote start.
See par. 6.5
Advance
2 H L
2 H L 1
Start of the regeneration at the programmed time at the command of the remote
start
Program
3 H L
3 H L 0
FLAG not used. Leave programmed at 0
Program
0 C L
0 C L 0
Modality of the litre counter divider. Do not use. See par. 6.6
Program
1 C L
1 C L 0
FLAG not used. Leave programmed at 0
Program
2 C L
2 C L 0
FLAG not used. Leave programmed at 0
Program
3 C L
3 C L 0
Management of salt alarm disabled
Advance
3 C L
3 C L 1
Management of salt alarm enabled. See par. 6.9
Program
0 d L
0 d L 0
Normal functioning
Advance
0 d L
0 d L 1
Management of the start of the regeneration in the case of inhibit. See par. 6.12
Program
1 d L
1 d L 0
FLAG not used
Program
2 d L
2 d L 0
FLAG not used
Program
3 d L
3 d L 0
FLAG not used
Program
Fast flashing of the display. The programming is memorised in eeprom.

SIATA Aqua Timer Plus Specifications

General

Brand	SIATA
Model	Aqua Timer Plus
Category	Controller
Language	English