Management of salt alarm disabled
Management of salt alarm enabled. See par. 6.9
Management of the start of the regeneration in the case of inhibit. See par. 6.12
Fast flashing of the display. The programming is memorised in eeprom.
6.2.5.c – List of codes to be programmed
For the programming and the meaning of the codes see par. 6.3. In this modality the programming of the following
codes is recommended:
Tab. 18 – Table of the codes in one duplex column modality LLL2 – LL–2
Programming of the regeneration cycle ( stop times )
Programming of the litre counter divider ( prescaler )
Programming of the duration of the end of cycle impulse and of the litre counter divider of the
dosing pump
Programming of the volume of resin, of the percentage of reserve and of the exchange capacity
Programming of the hardness value
Initialisation of the system
If the flag 0HL has been programmed with the value 1 to have also the regeneration by time, the recommended
programming varies as follows:
Tab. 19 – Table of the codes in the one duplex column LLL2 – LL–2
Programming of the time of regeneration and of the interval days between two regenerations
Programming of the regeneration cycle ( stop times )
Programming of the litre counter divider ( prescaler )
Programming of the duration of the end of cycle impulse and of the litre counter divider of the
dosing pump
Programming of the volume of resin, of the percentage of reserve and of the exchange capacity
Programming of the hardness value
Initialisation of the system
To Next Page
Loading...
