FLAG not used. Leave programmed at 0
Modality of the litre counter divider. Do not use. See par. 6.6
Standard regeneration. See par. 6.8
Regeneration with stand-by
Duplex distributor with standard cams. See par. 6.8
Duplex distributor with stand-by cams
Management of salt alarm disabled
Management of salt alarm enabled. See par. 6.9
Management of the start of regeneration in the case of inhibit. See par. 6.12
Fast flashing of the display. The programming is memorised in eeprom.
6.2.6.c – List of codes to be programmed
For the programming and the meaning of the codes see par. 6.3. In this modality the programming of the following
codes is recommended:
Tab. 21 – Table of the codes in one duplex column modality LLL2 – LL–3
Programming of the time of regeneration and interval days between two regenerations
Programming of the regeneration cycle (stop times )
Programming of the litre counter divider ( prescaler )
Programming of the duration of the end of cycle impulse and of the litre counter divider of the
dosing pump
Programming of the volume of resin, of the percentage of reserve and of the exchange capacity
Programming of the hardness value
Initialisation of the system
To Next Page
Loading...
Need help?
General
