SICK DS35 User Manual

Mounting
24 © SICK AG • Subject to change without notice • 8014868/YIF1/2020-10-19
5. Perform ne adjustment. Align the distance sensor such that the
highest possible alignment quality is indicated. The alignment quality is
indicated as follows:
• using the vertically arranged LEDs Q1 near to slow … fast: The great-
er the number of that LEDs light up, the higher the alignment quality.
• using the LEDs Q1 and Q2: The faster both LEDs ash, the higher
the alignment quality. Slow ashing at approx. 1 Hz corresponds to
poor alignment quality (no reective tape). Rapid ashing at approx.
15 Hz corresponds to high alignment quality (highest reective
level).
6. In order to leave alignment mode, either press the set pushbutton
longer than 5 seconds or wait 5 minutes without pushing the pushbut-
tons.
7. Remove the small reective tape for alignment from the object.
8. For DL35 and DR35 variants, attach a large reective tape for perform-
ing the measurement.
Q1 Q2
Q1 near
Q1 far
Q2 near
Q2 far
ObSB
select
set
run
ObSB
fastslow
set
>5s
Q1 Q2
Q1 near
Q1 far
Q2 near
Q2 far
ObSB
run
ObSB
fastslow
Q1 Q2
Q1 near
Q1 far
Q2 near
Q2 far
ObSB
run
ObSB
fastslow
1 Hz
15 Hz
Fig. 7: Aligning infrared light models, entering alignment mode

SICK DS35 Specifications

General

Brand	SICK
Model	DS35
Category	Accessories
Language	English