EasyManua.ls Logo

Side-Power SP 285 TCi - User Manual

Default Icon
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Keep this
manual onboard !
SIDE-
POWER
Thruster systems
D
Installations- und Bedienungsanleitung
Installation and user's manual
GB
Made in Norway
©
Sleipner Motor AS 2004
SLEIPNER MOTOR ASSLEIPNER MOTOR AS
SLEIPNER MOTOR ASSLEIPNER MOTOR AS
SLEIPNER MOTOR AS
P.O. Box 519
N-1612 Fredrikstad
Norway
Tel: +47 69 30 00 60
Fax:+47 69 30 00 70
www.side-power.com
sidepower@sleipner.no
SP 155 TC i/ SP 200 TCi
SP 240 TCi / SP 285 TCi

Table of Contents

Questions and Answers

  • S
    Shawn MooreAug 13, 2025
    Why does my Side-Power Outboard Motor thruster have low performance?
    • P
      Patricia ThomasAug 14, 2025
      A Side-Power Outboard Motor thruster might have unexpectedly low performance due to several reasons: * **Low Voltage:** If the voltage is less than 10,5 V / 21V, the thruster won't perform as expected. Check the voltage at the thruster while it's running. * **Brush Issues:** Inspect the brushes in the electromotor to ensure all brush-springs are correctly seated and have tension. * **Obstructions:** Check the propeller, gearhouse, and tunnel for any growth or obstructions like barnacles.
  • J
    Jennifer ConleyAug 19, 2025
    How to troubleshoot no thrust in my Side-Power Outboard Motor even though the electromotor runs?
    • R
      Regina ColemanAug 19, 2025
      If the electromotor of your Side-Power Outboard Motor runs but there's no thrust, consider these potential causes: * **Flexible Coupling:** Check the flexible coupling and motor installation to ensure the coupling is correctly connected before refitting the electromotor. * **Propeller Fastening:** Verify the propellers are securely fastened to the prop-shaft inside the tunnel and that the key is present. * **Gear Engagement:** With the motor removed, turn the driveshaft from inside the boat to feel if the gears are engaging and turning the prop-shaft. If there's a failure inside the gearhouse, it's recommended to replace the gearhouse.
  • R
    Richard ReyesAug 26, 2025
    What to do if my Side-Power SP 285 TCi Outboard Motor thruster runs for only 0.5 seconds every 10 seconds?
    • R
      Rachel AriasAug 26, 2025
      If your Side-Power Outboard Motor thruster runs briefly every 10 seconds, it could be due to solenoid lock-in, leading to auto stop and retry. Try shutting off the thruster main switch and gently tapping the solenoid to see if it releases. If the solenoid remains locked, replacement is necessary.
  • T
    Thomas RobinsonSep 1, 2025
    Why does my Side-Power SP 285 TCi thruster run for only 0.5 seconds every 4 seconds?
    • D
      David YoungSep 1, 2025
      If your Side-Power Outboard Motor thruster runs for about 0.5 seconds every 4 seconds, the most probable cause is low voltage, leading to solenoid flapping. Re-charge the battery(ies). If that's not enough, replace the battery(ies).
  • A
    Alyssa LopezNov 7, 2025
    What to do if my Side-Power SP 285 TCi Outboard Motor thruster doesn't start or only works in one direction?
    • A
      Aaron MartinezNov 7, 2025
      If your Side-Power Outboard Motor thruster isn't starting or is only working in one direction, here are a few things to check: * Verify that the voltage of the electromotor matches your installation by checking the labels. * If the main solenoids aren't engaging (clicking), try running the thruster without the panel by directly connecting the red and blue or red and grey wires in the control cable. * If the panel doesn't turn on, measure the voltage between the Red and Black wires in the connector going into the thruster. Also, inspect the internal wiring on the thruster motor, solenoids, and electronic motor interface box, comparing it to the wiring diagram. Ensure all connections are clean and tight. If there's no contact, the solenoid might be broken and need replacement. If the...

Summary

Technical Specifications

Planning and Installation Precautions

Tunnel and Thruster Positioning

Optimal Tunnel Length

Advice on achieving the best performance by selecting the correct tunnel length.

Tunnel End Shaping

Preventing Tunnel Drag

Sailboat Tunnel Installation

Series Production Tunnel Installation

Tunnel Installation Procedure

Fitting Gearhouse and Motor Bracket

Fitting Oil Tank and Propellers

Fitting the Electromotor

Electrical Installation Guidelines

Control Panel and Wiring

Visual Wiring Diagram (SP 155;200;240 TCI)

Technical Wiring Diagram (SP 155;200;240 TCI)

Electrical Installation for SP 285 TCI

Visual Wiring Diagram (SP 285 TCI)

Technical Wiring Diagram (SP 285 TCI)

Installation Checklist

User Precautions and Safety

How to Use Sidepower Thrusters

Using a Bowthruster

Step-by-step guide on operating the bowthruster for boat control.

Using a Stern Thruster

Instructions for operating a single stern thruster for stern movement.

Combined Bow and Stern Thruster Use

How to utilize both bow and stern thrusters for maximum maneuverability.

Maintenance Procedures

Troubleshooting Common Issues

Warranty Information

Side-Power SP 285 TCi Specifications

General IconGeneral
BrandSide-Power
ModelSP 285 TCi
CategoryOutboard Motor
LanguageEnglish

Related product manuals