EasyManua.ls Logo

Side-Power SP 155 TC i - User Manual

Side-Power SP 155 TC i
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Keep this
manual onboard !
SIDE-
POWER
Thruster systems
D
Installations- und Bedienungsanleitung
Installation and user's manual
GB
Made in Norway
©
Sleipner Motor AS 2004
SLEIPNER MOTOR ASSLEIPNER MOTOR AS
SLEIPNER MOTOR ASSLEIPNER MOTOR AS
SLEIPNER MOTOR AS
P.O. Box 519
N-1612 Fredrikstad
Norway
Tel: +47 69 30 00 60
Fax:+47 69 30 00 70
www.side-power.com
sidepower@sleipner.no
SP 155 TC i/ SP 200 TCi
SP 240 TCi / SP 285 TCi

Table of Contents

Questions and Answers

  • L
    larsonbethAug 7, 2025
    Why does my Side-Power SP 155 TC i Outboard Motor thruster have low performance?
    • M
      Martin DavidAug 7, 2025
      A Side-Power Outboard Motor thruster might have unexpectedly low performance due to several reasons: * **Low Voltage:** If the voltage is less than 10,5 V / 21V, the thruster won't perform as expected. Check the voltage at the thruster while it's running. * **Brush Issues:** Inspect the brushes in the electromotor to ensure all brush-springs are correctly seated and have tension. * **Obstructions:** Check the propeller, gearhouse, and tunnel for any growth or obstructions like barnacles.
  • M
    Mark BennettAug 13, 2025
    How to troubleshoot no thrust in my Side-Power SP 155 TC i Outboard Motor even though the electromotor runs?
    • M
      Megan ByrdAug 13, 2025
      If the electromotor of your Side-Power Outboard Motor runs but there's no thrust, consider these potential causes: * **Flexible Coupling:** Check the flexible coupling and motor installation to ensure the coupling is correctly connected before refitting the electromotor. * **Propeller Fastening:** Verify the propellers are securely fastened to the prop-shaft inside the tunnel and that the key is present. * **Gear Engagement:** With the motor removed, turn the driveshaft from inside the boat to feel if the gears are engaging and turning the prop-shaft. If there's a failure inside the gearhouse, it's recommended to replace the gearhouse.
  • V
    valdezgregAug 18, 2025
    What to do if my Side-Power SP 155 TC i Outboard Motor thruster runs for only 0.5 seconds every 10 seconds?
    • M
      Mary ReyesAug 18, 2025
      If your Side-Power Outboard Motor thruster runs briefly every 10 seconds, it could be due to solenoid lock-in, leading to auto stop and retry. Try shutting off the thruster main switch and gently tapping the solenoid to see if it releases. If the solenoid remains locked, replacement is necessary.
  • S
    shirleykirbyAug 26, 2025
    Why does my Side-Power Outboard Motor thruster run for only 0.5 seconds every 4 seconds?
    • L
      Lisa HartmanAug 26, 2025
      If your Side-Power Outboard Motor thruster runs for about 0.5 seconds every 4 seconds, the most probable cause is low voltage, leading to solenoid flapping. Re-charge the battery(ies). If that's not enough, replace the battery(ies).
  • H
    hurstisaiahOct 31, 2025
    What to do if my Side-Power SP 155 TC i thruster doesn't start or only works in one direction?
    • O
      omillerOct 31, 2025
      If your Side-Power Outboard Motor thruster isn't starting or is only working in one direction, here are a few things to check: * Verify that the voltage of the electromotor matches your installation by checking the labels. * If the main solenoids aren't engaging (clicking), try running the thruster without the panel by directly connecting the red and blue or red and grey wires in the control cable. * If the panel doesn't turn on, measure the voltage between the Red and Black wires in the connector going into the thruster. Also, inspect the internal wiring on the thruster motor, solenoids, and electronic motor interface box, comparing it to the wiring diagram. Ensure all connections are clean and tight. If there's no contact, the solenoid might be broken and need replacement. If the...

Summary

Product Overview and Installation Planning

Technical Specifications

Detailed technical data for motor, gearhouse, tunnel, propellers, and batteries.

Installation Planning and Safety Precautions

Essential planning, site requirements, and safety guidelines before installation.

Tunnel Installation Guide

Optimal Tunnel Placement and Design

Guidelines for tunnel positioning, depth, and length for efficiency and thrust.

Tunnel End Shaping and Drag Reduction

Optimizing tunnel ends and preventing drag for better performance.

Specialized Tunnel Installations

Techniques for sailboats and series production tunnel fitting.

Tunnel Installation Procedure

Step-by-step guide for fibreglass tunnel fitting and finishing.

Thruster Component Installation

Gearhouse, Motor Bracket, and Electromotor Installation

Installing the gearhouse, motor bracket, and electric motor components.

Oil Tank, Propeller, and Electrical System

Fitting the oil tank, propellers, and electrical system components.

Control Panel and Wiring Setup

Installing control panels and connecting control leads.

System Diagrams and Operation

Wiring Diagrams for SP 155;200;240 TCi

Visual and technical wiring diagrams for specific models.

SP 285 TCi Electrical and Wiring Diagrams

Specific electrical setup and wiring diagrams for the SP 285 TCi.

Operating Sidepower Thrusters

Instructions for using bowthrusters, sternthrusters, and combined systems.

Maintenance, Troubleshooting, and Support

Installation Checklist and Verification

Final checks to ensure correct installation and operation.

User Safety and Maintenance

Key safety guidelines and routine maintenance procedures.

Troubleshooting Common Issues

Diagnosing and resolving typical thruster problems.

Warranty and Service Centres

Warranty terms and contact information for global service centres.

Spare Parts Listing

Comprehensive lists of spare parts for different thruster models.

Side-Power SP 155 TC i Specifications

General IconGeneral
BrandSide-Power
ModelSP 155 TC i
CategoryOutboard Motor
LanguageEnglish

Related product manuals