2 Safety Instructions
These safety instructions include important information regarding your safety
and must be observed during installation and operation of SIEB & MEYER.
Read them carefully and keep them for later use.
Also adhere to safety instructions in the product documentation and on the
device.
2.1 General Information
WARNING
Risk of serious injuries and material damage
Any works regarding installation, initial operation and maintenance must be carried
out by trained staff only.Furthermore, electricians which connect feed-in systems
must be approved by the local DSO (distribution system operator).
Trained staff, according to this fundamental safety instruction, are persons familiar
with the installation, mounting, initial and permanent operation of the product and
they are qualified appropriately for the work. The standards DIN VDE 0100 and
DIN VDE 0110 as well as the national accident prevention regulations shall be
considered!
When installing feed-in systems adhere to all applicable regulations, special safety
instructions and technical connection conditions of the local DSO.
DANGER
Material may be damaged and persons be injured seriously:
▶ when covers are removed illegally,
▶ improper use
▶ when either the installation or the operation is incorrect
Observe the corresponding notes and information in the product documentation of
your device.
WARNING
Risk of injuries and material damage due to illegal modifications
Only change the settings of the device after having contacted SIEB & MEYER.
All Information and advice attached to the device, such as safety instructions or danger
warnings and technical data (type plate) are:
▶ not to be removed
▶ not to be damaged
▶ to be kept readably (no covers, no paint over or the like)
W
Safety Instructions
0460123A/0480123A/0480123D - 9
2
To Next Page
Loading...
