SIEB & MEYER CNC 8.00 Series - Troubleshooting; Network Error

3 Troubleshooting
During setup of the CNC 8x.00 Demo Kit errors might occur.
3.1 Network error
Fig. 15: Network error
Remedy
▶ Check the cable connections of the motion controller: Check the mains connection
and the Ethernet connection.
▶ Open the settings of the used network card and enter the IP address as shown in
the message (see section 2.1.1 "Setting the IP Address for the 2nd Network Card",
p. 7).
W
Troubleshooting
CNC 8x.00 - Demo Kit 17
3