1 Introduction
The CNC 8x.00 Demo Kit includes hardware and software components for production
planning on a separate work place.
This manual describes the Demo Kit for the CNC 84.00. You can apply the
described instructions to the CNC 82.00. Then, use the operating software of
the CNC 82.00 with the motion controller MC82.
1.1 Function
Compared with the operation of the CNC on a machine the Demo Kit offers only limited
functionalities. The motion controller is provided with a special dongle that does not
support normal operation of the motion controller on a machine.
After installation and setup of the CNC 8x.00 Demo Kit has been finished the CNC
works in the simulation mode.
1.2 Components
1.2.1 Hardware
The CNC 84.00 Demo Kit contains the following hardware components:
▶ Motion Controller MC84 in housing
▶ Ethernet cable X11 (Cross Over, Cat 5e)
▶ external power supply unit (input: 100 to 240 V
AC
/ ~1.6 A / 50 to 60 Hz / output:
24 V
AC
/ 2.5 A) with connection cable X10
When delivered in countries where other mains plug standards apply than in
Germany, the external power supply unit is not part of delivery. In this case,
consider connection example B (p. 10). Otherwise, consider connection
example A (p. 9).
For PCs equipepd with one network card, only, you need an USB > Ethernet
adapter which is not part of delivery
You can for example use the USB 2.0 > LAN 10/100 Mb/s adapter by Delock
(article number of Delock: 61147).
1.2.2 Software
The following software is required for the CNC 84.00 Demo Kit:
▶ Operating software of the CNC 84.00
Contact the SIEB & MEYER service department to get the installation file (cnc-
service@sieb-meyer.de).
W
Introduction
CNC 8x.00 - Demo Kit 5
1
To Next Page
Loading...