9
Last update: 01.08.2013
Operating instructions
GENIUS
Programming in the infra-red master key
› Retract all locking elements.
› Open the door and hold it open.
› Switch off the operating voltage.
› Switch on the operating voltage.
› The red LED in the infra-red eye will flash.
› Hold the infra-red master key in front of the infra-red eye and press the button on it several times.
› The red LED in the infra-red eye will light up
› An acoustic signal is generated to indicate that programming was successful.
All infra-red access keys must now be programmed in again.
Programming in infra-red access keys
Note: Before the infra-red access key is programmed in, the infra-red master key must first be programmed in.
› Retract all locking elements.
› Open the door and hold it open.
› Hold the infra-red master key in front of the infra-red eye and press the button on it several times.
› The red LED in the infra-red eye will flash.
› Hold the access key in front of the infra-red eye and press any button on it.
› An sequence of beeps is generated to confirm that programming was successful.
› To check that programming was successful, press the "open" button on the infra-red access key once more.
Deleting infra-red access keys
Important: The delete process always deletes all infra-red access keys.
› Retract all locking elements.
› Open the door and hold it open.
› Switch off the operating voltage.
› Switch on the operating voltage.
› The red LED in the infra-red eye will flash.
› Hold the infra-red master key in front of the infra-red eye and press the button on it several times.
› The red LED in the infra-red eye will light up.
› An acoustic signal is generated to indicate that programming was successful.
All infra-red access keys must now be programmed in again.
Setting up the fingerprint scanner
To set up the fingerprint scanner, follow the "Fingerprint scanner access control" operating instructions.
To Next Page
Loading...