4 Last update: 01.08.2013
GENIUS
Operating instructions
Switching the acoustic signal on and off
In its "supplied" state, GENIUS beeps as it draws the latch electronically into the changeover function.
It emits a constant beep for as long as terminal 4 receives an "open" signal. In some cases this constant beep is undesirab-
le, e.g. if the door needs to be kept unlocked to provide permanent access at certain times.
In this instance,GENIUS can be prevented from beeping by programming it as described below.
1.) Retract all locking elements
2.) Open the door and hold it open
3.) Switch off the operating voltage
4.) Switch on the operating voltage
5.) GENIUS now switches to programming mode (a sequence of beeps is heard)
6.) Press the "open" button, release it (for about 1 s), then press and hold it down once again.
7.) An sequence of beeps is generated to indicate that programming was successful
These programming steps can be followed any number of times in order to switch between the following two modes:
- GENIUS beeps as the latch is drawn into the changeover function
- GENIUS does not beep as the latch is drawn into the changeover function
Whichever mode is currently selected will remain active even if the power supply is interrupted.
To Next Page
Loading...
