Siegenia GENIUS - Door Locking and Unlocking; Locking Procedures; Unlocking Procedures

5
Last update: 01.08.2013
Operating instructions
GENIUS
Locking and unlocking the door
WARNING
Operating the handle during automatic locking or unlocking can place excessi-
ve strain on the lock and damage the main lock case or the GENIUS door lock.
> Do not operate the lever handle during automatic locking and unlocking.
Locking the door
In day mode the door can be locked as follows:
• Manually with the cylinder key
• Using an (optional) KFV infra-red access key
• Using an (optional) KFV fingerprint scanner
All of the above methods involve the engagement of all locking elements.
When the door is closed in night mode, it is automatically locked and all of its locking elements retract.
Unlocking the door
The door can be opened manually using the cylinder key, or automatically by using an external access control system
(handheld wireless transmitter, infra-red access key, transponder or fingerprint scanner).
If the door is fitted with a type CA/CB GENIUS lock, it can also be unlocked from the inside with the lever handle.
› Press the lever handle down fully.
› This causes all locking elements including the latch to retract.
Important:
• To lock or unlock the door with the cylinder key, always turn it as far as it will go.
The key must then be turned back some way before it can be removed from the lock.
• If the door does not open immediately following automatic unlocking, a signal will be heard for approximately
7 seconds.
In night mode, the door will then lock again automatically.