Siemens 7KT0310 - Assembly; Panel Installation

7
SMART 7KT0310 Manual
Assembly

Installation
For installing the meter
Preparethepanelcutoutwithproperdimensionsasshownbelow.
FRONT PANEL DESCRIPTION
OUTLINE
Dimensions (in mm)
PANEL CUTOUT
Dimensions (in mm)
90.5
50
96
5
96
91.5
91.5
1. Insert unit into the panel 2. Positiontheclamps(asshowninthe
gure)andpushthesameintotheslots
intheirrespectivelocations.
3. Push/Slideall4clampstowardsthepanel
evenlytillthelowestpossibletoothof
theclampisengaged.Ensure the meter
is properly tightened and it does not
move.
PANEL
GASKET
UNIT
1
2
3
4
Base clamp
position
Base clamp
position
SLIDING
CLAMP
SLIDING
CLAMP
Note:Terminalscrewtighteningtorque:0.7N-mto0.8N-m(6In-Lbto7In-Lb)
Thedistancetobemaintainedbetweentwometerswhile
mountingonapaneldoorshouldbeatleast100mm.
100 mm
100 mm 100 mm
100 mm
Mounting distance