10 / 18 Supplement to User and Reference Manuals
Configuring a Connection to a Wireless Network
You can enable and disable connections to wireless networks without a password even when
changes to the wireless network options are protected by a password.
Note: If the ultrasound system is connected to both a wireless network and a local area network
(LAN), the system uses the LAN connection for sending files to network locations.
To configure a connection:
Prerequisite: The wireless adapter is connected to the leftmost USB port on the Input/Output panel
of the ultrasound system.
1. Access the system presets.
2. Select Wireless.
3. Enter a password, if required.
To: Do This:
Activate a connection to a wireless
network
Note: Siemens recommends using secured networks to ensure data security.
Select Enabled.
Deactivate the connection to a
wireless network
Select Disabled.
Connect to the selected network
1. Click Scan to refresh the list of wireless networks.
Note: The wireless adapter must remain connected to the ultrasound system
while refreshing the list.
2. Select a network from the list.
3. Click Connect.
4. If the system displays the Network Profile Settings dialog box, enter the
required profile settings and then click OK.
The ultrasound system displays the wireless icon indicating a connection to
a wireless network and the signal strength on the status bar.
See also: Informational Icons for the Wireless Adapter, p. 6
Disconnect from the selected
wireless network
1. Select the connected network from the list.
2. Click Disconnect.
The ultrasound system disconnects from the wireless network. If connected
to a LAN, the system reverts to using the LAN connection for sending files to
network locations.
To Next Page
Loading...
