Siemens C75 - Page 32

Calling32
© Siemens AG 2003, C:\Siemens\DTP-Satz\Produkte\C75_Aries_1\Output\FUG\C75_FUG_FCC_us-en_050608_te\Aries_Phone.fm
Template: X75, Version 2.2; VAR Language: am; VAR issue date: 050524
left page (32) of C75 FCC, us-en FUG am, (09.06.2005, 08:40)
When the new connection is
established:
§Toggle§ Swapping between calls.
Incoming calls during a call
You may need to register for this ser-
vice with your service provider and
set your phone accordingly (p. 89).
During a call, you may be advised
that there is another call waiting. You
will hear a special tone during the
call. You have the following options:
• Accept the waiting call in addition
to the first
§Toggle§ Accept the waiting call,
putting the current call on
hold to do so.
Always proceed as above to swap be-
tween the two calls.
• Reject the waiting call
§Reject§ Press.
Or
§Forward§ The waiting call is divert-
ed, for example, to the
mailbox.
• Accept the waiting call and end the
current call
B
End the current call.
C
Accept new call.
Ending call(s)
B
Press the End key.
After the Return to held call? display,
you have the following selection:
§Yes§ You accept the call on hold.
§No§ You end the 2nd call.
Conference b
Call up to 5 parties one by one and
link them together in a multiparty
call. Some of the functions described
may not be supported by your ser-
vice provider or may have to be en-
abled specially.
A connection has already been
established:
§Options§ Open menu and select
Hold. The current connec-
tion is maintained.
J
Now dial a new number.
When the new connec-
tion is established ...
§Options§ … open menu and select
Conference. The held call is
joined.
Repeat procedure until all partici-
pants are linked together (up to
5participants).
End
B
All calls in the multiparty
conversation are ended
when the End key is
pressed.