Check the box <Continue image upload> to upload the triggered images during
certain time or keep uploading until the trigger is off. Select <Upload for __ sec>
and enter the duration in the blank. The images of the duration will be uploading by
E-mail when the alarm input is triggered. The setting range is from 1 to 9999 sec-
onds. Select <Upload during the trigger active> to make the images keep being
uploaded to E-mail during the trigger active until the alarm is released. Set the Im-
age frequency as the upload frame rate. The setting range is from 1 frame to 15
frames.
NOTE: Make sure SMTP configuration has been completed. Refer to Mail for fur-
ther details.
Send HTTP notification
Check this item and select the destination HTTP address. Then specify the pa-
rameters
for
event
notifications
by
<Alarm
>
triggere
d.
W
hen
an
alarm
is
triggered,
the HTTP notification will be sent to the specified HTTP server.
For instance, if the custom parameter is set as “action=1&group=2”, and the HTTP
server name is “http://192.168.0.10/admin.php”, the notification will be sent to
HTTP server as “http://192.168.0.10/admin.php? action=1&group=2” when alarm
is triggered.
Record to Video Clip
Select the item and the alarm-triggered recording will be saved into the microSD
card.
Pre-trigger buffer recording function allows users to check what happened to
cause the trigger. The pre-trigger buffer time range is from 1 to 3 seconds.
Select <Upload for __ sec> to set the recording duration after alarm is triggered.
The setting range is from 1 to 99999 seconds.
Select <Upload during the trigger active> to record the triggered video until the
trigger is off.
NOTE: Please make sure the local recording (with microSD / SDHC card) is acti-
vated so that this function can be implemented.
To Next Page
Loading...
