12.3.18 Schedule
The Schedule setting can be found under this path: System> Schedule.
This
function
a
llows
the
us
ers
to setup
schedules
fo
r
features
including
:
<Alarm
Switch>, <Motion Detection>, <Network Failure Detection> and <Tampering>. The
function supports up to 10 sets of time frames in the time frame list.
Setting Schedules
To set a schedule, please select a time frame from the time frame list first. Then
check the boxes from below to choose the specific weekdays. At last, type in the
start time (hour:minute) and the duration time (hour:minute) for activation of the
schedule triggered features. The setting range for the duration time is from 00:00
to 168:59. Click <Delete> to delete a chosen time frame. Please click on <Save>
to save the setup.
NOTE: Users MUST select <By schedule> under each feature setting page to en-
able the schedule function.
To Next Page
Loading...
