16/30
Siemens Climatix touch
panel A6V10445442_en--_a
Building Technologies Mounting and connecting 2015-06-30
4.3.2 Connect configuration PC
A configuration PC can:
• Transfer a project
• Reset the Climatix touch panel to factory settings
• Back up, recover, or configure recipes
Use a CAT5 Ethernet cable or higher to connect the configuration PC.
1. Connect one RJ45 connector on a LAN cable to the Climatix touch panel.
2. Connect the other RJ45 connector on the LAN cable to the configuration PC.
3. Configure the network of the Climatix touch panel if necessary. See Configure
the Network.
Use a USB cable to connect the configuration PC. The USB cable has a standard
USB Type B male connector on one end.
1. Connect the USB cable to the USB-A port on the Climatix touch panel.
2. Connect the other end of the USB cable to the configuration PC.
To Next Page
Loading...
