Siemens Climatix POL8T1.4X/STD - Configuring the Climatix Touch Panel; Set Screen Brightness; Set the Time and Date

22/30
Siemens Climatix touch
panel A6V10445442_en--_a
Building Technologies Configuring the Climatix touch panel 2015-06-30
6. Configuring the Climatix touch panel
You can configure the Climatix touch panel settings:
• Screen brightness
• System date and time
• Network configuration
• Serial port test
• Language
To access Settings mode:
1. Shut down the Climatix touch panel.
2. Manually set the DIP switches to the position 01000.
3. Switch on the Climatix touch panel.
All settings are stored even if the Climatix touch panel is powered off.
6.1 Set screen brightness
Press Brightness, and adjust the brightness of display.
6.2 Set the time and date
Press Date / time and use + or - to set the date and time, and press Ok.
Note: