Opening and closing the housing cover when the power supply is switched off
Closing the housing cover
The size 2 Phillips screwdriver and the two screws are available.
The power supply is switched off.
1. Slide the housing cover in the opposite direction to the arrow (step 2) until it
reaches the end position at the bottom.
2. NOTICE! Connection cable clamped between the back box and the housing
cover. Damage to the cable! Be aware of the connection cable when closing
the housing cover.
3. Screw the housing cover to the housing base with the two screws. Tighten the
screws by hand (step 1).
The housing cover is closed.
8
Building Technologies A6V10345654_h_en_--
Fire Safety 2015-05-29
To Next Page
Loading...
