6
HART add-on module
4. Product interfaces
4.1 Mechanical
Installation
MAG 5000 C HART
The MAG 5000 C HART is delivered with a build-in HART interface. It is not possible to add
additional modules to the MAG 5000 C.
Before proceeding, please make sure that you have the right HART Add-on module. The
correct module for MAG 6000 and MASS 6000 is FDK:085U0226. The order number is
located on the label of the module.
The installation procedure for the HART module is as follows:
4.2 Mechanical
Installation
MAG/MASS 6000
4. Product interfaces
1. Unpack the add-on module and
insert it in the bottom of the signal
converter as shown.
19” rack mounted versions IP 67 compact versions
This completes the add-on module
installation, and the signal converter
may now be connected to the terminal
box. Communication with the display/
keypad and the electrical input/output
terminals is established automatically
when the power is applied.
2. Press the add-on module in the
direction shown, until it stops and
is firmly seated in position.
To Next Page
Loading...
