20
HART add-on module Tables / 12. Performance / 13. Annex A Capability Checklist
11.6 Density unit codes
Unit code Description Note
91 Grams per cubic centimetre
92 Kilograms per cubic meter
93 Pounds per gallon
94 Pounds per cubic foot
95 Grams per milliliter
96 Kilograms per liter
97 Grams per liter
98 Pounds per cubic inch
246 Tons per cubic meter
251 No Conversion
13. Annex A
Capability Checklist
Manufacturer Siemens
Model SITRANS F M Magflo MAG 5000 C
SITRANS F M Magflo MAG 6000
SITRANS F C Massflo MASS 6000
Device type Transmitter
HART protocol revision 5.2
Device descriptions PDM
Number of dynamic variables MAG: 3
MASS: 4
Mappable dynamic variables No
Number of Common-Practice commands 12
Number of Device-Specific commands 35
Bits of additional device status 76 bits informational (25 bytes in total)
Alternative operating modes No
Burst Mode Yes
Write protect No
12. Performance
12.1 Sampling rates
MAG 5000 C/6000
PV digital calculation (Volume flow) Equals the Excitation frequency
SV digital calculation (Totalizer 1) 2 per second
TV digital calculation (Totalizer 2 / Batch) 2 per second
Analog output update Equals the Excitation frequency
The excitation frequency is dependent on the sensor type and size. Large sensors have low
excitation frequencies and small sensors have high excitation frequencies (up to 30 Hz).
The excitation frequency can be viewed in the local keypad display under „Sensor characteristics“
menu.
12.2 Sampling rates
MASS 6000
PV digital calculation (Massflow) 2 per second
SV digital calculation (Density) 2 per second
TV digital calculation (Temperature) 2 per second
QV digital calculation (Volume flow) 2 per second
Analog output update 30 per second
To Next Page
Loading...
