Siemens FDOOT241-A9-Ex - Configuration

Undertaking modernization
4
Step 2: Replacing the control panel and changing over to FDnet-Ex/C-NET-Ex protocol
4.2.5 Configuration
The multiple protocol detectors are configured directly on the control panel or using
the relevant configuration software for the fire control panel.
You will find information about configuration with the software for the respective fire
detection system in the following documents:
Fire detection
system
Software
Document ID
FS20 SintesoWorks 009078
FS720 Cerberus Engineering Tool A6V10210424
See chapter 'Applicable documents [➙ 8]'.
23
Building Technologies
A6V10443621_a_en_--
Fire Safety 2014-09-01