Need help?Do you have a question about the Siemens FDOOT241-9 and is the answer not in the manual?
General| Product Type | Optical Smoke Detector |
|---|---|
| Protection Category | IP40 |
| Weight | Approx. 120 g |
| Sensor Technology | Optical |
| Operating Voltage | 12-33 V DC |
| Operating Temperature | -10°C to +55°C |
| Humidity Range | ≤ 95% RH (non-condensing) |
| Compatibility | Siemens |
Outlines the document's aim to provide consistent information for correct and safe use of fire detectors.
Identifies intended audiences for the manual, including product managers and installation personnel.
Explains the importance of safety notices and their components like signal words and danger symbols.
Details national standards, electrical installation safety, and assembly/installation procedures.
States that a list of complied standards and directives is available from Siemens.
Summarizes the automatic fire detectors covered in the document and their different names.
Differentiates between S-LINE and C-LINE detector product lines based on application range and features.
Introduces the types of detectors available: Neural fire, Wide-spectrum smoke, and Heat detectors.
Covers various operational aspects of the detectors, including parameter sets and danger levels.
Covers the requirements for installing detector bases and detectors.
Lists various accessories and optional components for detectors.
Outlines detector compatibility with different detector lines and protocols.
Discusses factors like room geometry, deceptive phenomena, and risk of fire for parameter set selection.
Details various parameter sets for neural fire detectors and their applications.
Details parameter sets for wide-spectrum smoke detectors and their applications.
Details parameter sets for heat detectors and their specifications.
Lists the default parameter sets for various detectors.
Specifies the necessary clearance and space around detectors for installation and testing.
Explains the cable routing and installation for detector bases FDB201 and FDB221.
Explains the cable routing and installation for detector bases FDB202 and FDB222.
Details the use of the FDB293 base attachment for wet room installations.
Explains the installation of the detector heating unit.
Covers the installation of protective and EMC-protective cages.
Provides general cabling information for detector lines.
Describes the commissioning process for detectors on an FDnet.
Details considerations when migrating from collective to FDnet detector lines.
Explains how to poll detector status using the exchanger and tester.
Outlines regular performance checks and recommendations for detector service life.
Covers methods and accessories for testing detectors.
Provides detailed technical specifications for FDOOT241-x and FDOOT221 detectors.
Provides detailed technical specifications for FDO221 and FDO241 detectors.
Provides detailed technical specifications for FDT221 and FDT241 detectors.
Shows the physical dimensions of detector bases.
Discusses environmentally friendly aspects of the detectors.
To Next Page
