Structure and function
32
Building Technologies 007004_k_en_--
Fire Safety & Security Products 16.04.2009
3.5 Mechanical setup
To install a point detector, a detector base is always required. After mounting the
detector base the point detector is simply screwed into the base by hand with the
detector exchanger or with the detector exchanger and tester.
Properties
z Quick installation and reliable contact due to screwless terminals
z Insertion of the insulated wires without any tools
z The centered alarm indicator makes an alignment of the detector base
superfluous
z Space for up to 6 auxiliary terminals for detector heating units etc.
A wide range of accessories that can be combined for the corresponding
application is available for the different applications.
See also
Options [J 33]
Mounting / Installation [J 57]
To Next Page
Loading...
