Siemens FT2011 User Manual

About this document
Displays used in document
1
5 |
32
Building Technologies
009311_k_en_
--
Fire Safety
2015
-
12
-
15
1 About this document
Goal and purpose
This document describes the operation of the floor repeater display FT2011 in a
fire detection system. The reader shall become familiar with the possible
indications and operating functions on the floor repeater display, as well as with the
functionality of the floor repeater display in the overall system. This understanding
makes an adequate behaviour possible in the event of fire or fault.
Scope
This document applies to the floor repeater display type FT2011.
Target groups
The information in this document is intended for the following target groups:
Target group Activity Qualification
Operating personnel
● Carries out procedures to
correctly operate the product.
● No particular basic training is needed.
● Has been instructed by the
commissioning personnel.
Commissioning personnel
● Configure the product at the
place of installation according to
customer-specific requirements.
● Check the product operability
and release the product for use
by the operator.
● Searches for and corrects
malfunctions.
● Has obtained suitable specialist training
for the function and for the products.
● Has attended the training courses for
commissioning personnel.
Maintenance personnel
● Carries out all maintenance
work.
● Checks that the products are in
perfect working order.
● Searches for and corrects
malfunctions.
● Has obtained suitable specialist training
for the function and for the products.
Source language and reference document
● The source/original language of this document is German (de).
● The reference version of this document is the international version in English.
The international version is not localized.
Document identification
The document ID is structured as follows:
ID code Examples
ID_ModificationIndex_Language_COUN
TRY
-- = multilingual or international
A6V10215123_a_de_DE
A6V10215123_a_en_--
A6V10315123_a_--_--
Date format
The date format in the document corresponds to the recommendation of
international standard ISO 8601 (format YYYY-MM-DD).

Siemens FT2011 Specifications

General

Brand	Siemens
Model	FT2011
Category	Measuring Instruments
Language	English