6
Preparing to use your phone
Gigaset C1 / englisch / A31008-C001-B001-1-6Z19 / start_guide_time.fm / 21.03.2003
Preparing to use your phone
The pack contains:
◆ one Gigaset C 1 handset,
◆ one charging shell,
◆ two batteries,
◆ one power supply unit with power cord,
◆ one set of operating instructions.
Preparing to use the handset
The display is protected by a plastic film. Remove the protective plastic film!
Inserting the batteries
◆ Insert the batteries ensuring correct polarity – see figure on left.
◆ Position the battery cover so that it is open by around 3 mm, then slide up until it
closes with a click,
◆ To open the battery cover, press on the chequered area and slide down.
Placing the handset into the base (registering) and charging the batteries
When you place the C 1 handset into the C 100/C 150, C 200/C 250 or S 100/S 150 base,
it will register to the base automatically. Proceed step by step as follows:
1. Place the handset in the base with the display up.
2. Wait till the handset has registered automatically to the base: This operation takes
around one minute. While registration is in progress the screen displays
Registering and Base 1 flashes. The allocated internal number appears in the top
left of the display after registration.
3. Now leave the handset in the charger for the batteries to charge - the batteries are
supplied uncharged. Battery charging is indicated in the top right of the display by
the flashing battery icon =.
W
Use only the rechargeable batteries recommended by Siemens on
page 18! Never use conventional batteries (non-rechargeable) or other
battery types as this may cause significant damage to health and prop-
erty. For example, the jacket of the battery could be destroyed (hazard-
ous). The phone could also malfunction or be damaged.
To Next Page
Loading...
