Siemens Gigaset C1 - Manual Registration

7
Preparing to use your phone
Gigaset C1 / englisch / A31008-C001-B001-1-6Z19 / start_guide_time.fm / 21.03.2003
The battery charging status is correctly displayed only after uninterrupted charging/dis-
charging. You should therefore avoid removing the batteries unnecessarily and ending
the charging process prematurely.
Manual registration
If automatic registration is interrupted or if you wish to use your C 1 handset at a differ-
ent Gigaset base (1000, 2000, 3000 or 4000 family), then you must register it manu-
ally. You must initiate handset registration on the handset and on the base.
1. On the handset
Base 1 flashes in the display when the system PIN has been entered.
2. On the base
Please refer to the operating instructions for the base to find out how to prepare the
base for registration.
W
For the initial charge we recommend a continuous, uninterrupted charg-
ing period of five hours, whatever charge status is indicated. After a while
the charge capacity of the batteries will decrease for technical reasons.
i
◆ Once initial charging is complete, you can replace your handset in the
charging shell after each call. Charging is controlled electronically.
This ensures that the batteries are charged in a way that maximises
their life.
◆ The batteries heat up during charging. This is normal and not danger-
ous.
[ _______________]
MENU
Press the display key to open the menu.
[__________] [_____________________________________________________________]
Handset Settings
[_________]OK
Select the menu item and confirm.
[__________] [_____________________________________________________________]
Register Handset
[_________]
OK
Select the menu item and confirm.
[________]OK
Enter the system PIN of the base (the default is 0000)
and confirm.