Siemens Gigaset C475 IP - Operating the Base Station on the PABX; Changing the Dialling Mode; Setting Recall; Setting Pauses

111
Changing the dialling mode Operating the base station on the PABX
Gigaset C470-475 IP / EN for IM-Ost / A31008-xxxx-xxxx-x-xxxx / settings_bs_hs_pabx.fm / 16.8.07
Version 2.1, 08.01.2007
Operating the base station on the PABX
The following settings are only necessary when your PABX requires them; see the PABX
user guide. The settings only concern fixed line network connections.
You cannot send or receive SMS messages on PABXs that do not support Calling Line Iden-
tification.
Changing the dialling mode
You can set the dialling mode.
v ¢ Ð Settings ¢ Telephony ¢ Fixed Line ¢ Dialling Mode
Tone / Pulse Select and press §OK§ (=on).
a Press and hold (idle status).
Setting recall
You can set the recall option.
v
¢ Ð Settings ¢ Telephony ¢ Fixed Line ¢ Recall
q Select recall and press §OK§.
The current setting is indicated by .
a Press and hold (idle status).
Setting pauses
Changing pause after line seizure
You can set the length of the pause inserted between pressing the talk key c and sending
the phone number.
v55O L
~ Enter a number for the length of the pause (1 = 1 sec.; 2 =3sec.; 3 =7sec.)
and press
§OK§.
a Press and hold (idle status).
Changing the pause after the recall key
You can change the length of the pause if your PABX requires this (refer to the user guide
for your PABX).
v55O
~ Enter a number for the length of the pause (1 = 1 sec.; 2 = 2 sec.; 3 = 3 sec.;
4 = 6 sec.) and press
§OK§.
a Press and hold (idle status).
‰
‰
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299