77
Operating the base station answer machine
Activating/deactivating call screening
Gigaset C470-C475 IP / GBR / A31008-M1916-L101-1-7619 / answering_m.fm / 7.2.08
Version 2.1, 08.01.2007
Activating/deactivating call screening
During recording of a message you can screen a call via the handset loudspeaker.
Precondition: The number called is assigned to the handset as a receive number
(page 144).
Permanently activating/deactivating call screening
v ¢ Ð Settings ¢ Voice Mail ¢ Local AM
Call Screening
Select and press
§OK§ (=on)
a Press and hold (idle status).
Deactivating call screening for the current recording
You can deactivate the Call Screening function for the current call during recording via the
handset.
a Briefly press the end call key.
Setting up the answer machine
The answer machine has already been preset at the factory. Make individual settings using
the handset.
Call acceptance/charge saving function for remote operation
You can set when you want the answer machine to accept a call.
The options are: 0 sec., after 10 sec., 18 sec. or 30 sec. and the cost-saving setting Automatic.
In Automatic mode, the following applies for call acceptance:
u If there are no new messages, the answer machine accepts a call after 18 seconds.
u If new messages are present, the answer machine accepts a call after 10 seconds.
When operating remotely you can tell after approx. 15 seconds that there are no new mes-
sages (otherwise the answer machine would already have accepted your call). There will
be no call charges if you hang up now.
v
¢ Ð Settings ¢ Voice Mail ¢ Local AM ¢ Ring Delay
r Select 0 sec. / 10 sec. / 18 sec. / 30 sec. / Automatic.
§Save§ Press the display key.
a Press and hold (idle status).
‰
To Next Page
Loading...
