154
Configuring the system settings
Gigaset C590 IP / IM-OST EN / A31008-M2215-R601-1-TE19 / settings.fm / 22.12.10
Version 4, 16.09.2005
The following lists are deleted:
u SMS lists
u Call lists
v ¢
Ï
¢ System ¢ Base Reset
~ Enter the system PIN and press §OK§.
§Yes§ Press the display key.
After the reset, the base is restarted. The restart takes around ten seconds.
The installation wizard is launched (
¢ page 23).
Resetting the base using a key on the base
As with resetting the base via the menu, all individual settings are reset. The system
PIN is also reset to "0000" and all handsets registered above and beyond the
scope of delivery will be de-registered.
¤ Remove the cable connections from the base to the router (¢ page 21) and
fixed line (
¢ page 19).
¤ Remove the base power adapter from the socket (¢ page 19).
¤ Press and hold the registration/paging key (¢ page 5).
¤ Plug the power adapter back into the power socket.
¤ Press and hold the registration/paging key (at least 20 sec.).
¤ Release the registration/paging key. The base has now been reset.
Restarting the base
When the handset is in idle status:
v ¢
Ï
¢ System ¢ Base Restart
The firmware for the base is then rebooted. This process takes about 20 seconds.
Checking the base MAC address
Depending on your network configuration, you may have to enter your base
MAC address in your router's access control list, for example. You can check the
MAC address on the handset.
In idle status:
v Open menu.
*#Q5#2Q
Press keys in sequence.
The MAC address is displayed.
§Back§ Return to idle status.
Please note
For instructions on re-registering the handsets after a reset (where applicable),
¢ page 127.
To Next Page
Loading...
