Siemens Gigaset C590 - Activating;Deactivating SMS Function; SMS Troubleshooting

48
Setting the alarm clock
Gigaset C590 / IM-NORD EN / A31008-M2101-R201-1-SM19 / registr_sett.fm / 29.06.2009
Version 4, 16.09.2005
Setting the alarm clock
Precondition: The date and time have
already been set (
¢ page 14).
Activating/deactivating the alarm
clock and setting the wake-up time
v ¢ É ¢ Alarm Clock
¤ Change multiple line input:
Activation:
Select On or Off.
Time:
Enter the wake-up time in 4-digit for-
mat.
Volume:
Set the volume (1–6).
Melody:
Select melody.
§Save§ Press the display key.
In idle status, the ¼ icon and wake-up
time are displayed.
A wake-up call is signalled on the display
and with the selected ringtone
(
¢ page 2). The wake-up call sounds for
60 seconds. If no key is pressed, the wake-
up call is repeated twice at five minute
intervals and then switched off.
During a call, the wake-up call is only sig-
nalled by a short tone.
Deactivating the wake-up call/
repeating after a pause (snooze mode)
Precondition: A wake-up call is sounding.
§OFF§ Press the display key. The
wake-up call is deactivated.
or
§Snooze§ Press the display key or any
key. The wake-up call is deacti-
vated and then repeated after
5 minutes. After the second
repetition the wake-up call is
deactivated completely.
Using several handsets
Registering handsets
You can register up to six handsets to your
base.
A Gigaset C59H handset can be registered
on up to four bases.
Manual registration of the
Gigaset C59H on Gigaset C590
You must activate manual registration of
the handset on both the handset and the
base.
When the registration process has com-
pleted successfully, the handset returns to
idle status. The handset's internal number
is shown in the display e.g. INT 1. If not,
repeat the procedure.
On the handset
The handset must not be registered to a
base.
§Register§ Press the display key.
The handset is already registered to a
base:
v
¢
Ï
¢ Registration
¢ Register Handset
If the handset is already registered on four
bases:
s Select base, e.g. Base 3 and
press
§OK§.
~ If required, enter the system
PIN for the base and press
§OK§.
A message displays that a search for a base
that is ready for registration is being car-
ried out.
On the base
Within 60 seconds press and hold the reg-
istration/paging key on the base
(
¢ page 1) (approx. 3 seconds).