Siemens Gigaset SL100 - Vibration Alarm

68
Handset settings
Gigaset SL 100 / AUS/NZL / A31008-L100-L102-1-7619 / settings_bs_hs.fm / 08.03.2004
Activating/deactivating the ringer
All handsets ring when there is an incoming call. You can cancel the ringer on your
handset before you answer a call or when the handset is in idle status; the ringer can be
cancelled permanently or just for the current call.
To cancel the ringer in the idle status, press the P key and hold until the
Ú icon
appears. The ringer cannot be re-activated while an external call is in progress.
Activating/deactivating the alert tone
When you activate/deactivate the ringer you can activate an alert tone. When you get a
call, you will hear a short tone (beep) instead of the ring tone.
Vibration alarm
Incoming calls and other messages are signalled with a vibration. This setting is inde-
pendent of the ringer settings.
v ¢ Audio Settings
Cancelling the ringer permanently:
P
Press the star key and hold until the ringer cannot be
heard any longer. The ringer is now permanently
cancelled. The
Ú icon appears in the display.
Re-activating the ringer:
P
Press the star key and hold.
i
To cancel the ringer for the current call, press the display key Silence.
P
Press the star key and hold and within 3 seconds:
[RRRRRRRRRRRRRRRRRRRRR]
Beep on
Press the display key. Then an incoming call is sig-
nalled by a short alert tone. You will now see
º
in
the display.
Activating/deactivating the alert tone:
P
Press the star key and hold. The ringer is switched on
again.
Silent Alert
Confirm (‰ = On).
a
Long press (back to idle status).
OK