Siemens Gigaset SL100 - Changing the Name of the Base Station; Repeater Support; Restoring the Base Station to Factory Settings

74
Setting the base station
Gigaset SL 100 / AUS/NZL / A31008-L100-L102-1-7619 / settings_bs_hs.fm / 08.03.2004
Changing the name of the base station
The names "Base station 1" to "Base station 4" are assigned automatically. You can
change the name of your base station.
v ¢ Settings ¢ Select Base
Repeater support
With a repeater you can increase the range and reception strength of your base station;
the repeater has to be registered. To use the repeater you first have to activate the
repeater mode. This will cancel any calls that are in progress.
v ¢ Base Settings ¢ Add. Features
Restoring the base station to factory settings
Resetting does not affect the system PIN and handsets are still registered.
v ¢ Base Settings ¢ Base Reset
[RRRRRRRRRRRRRRRRRRRRR]
Edit
Select the base station and press the display key.
~ Enter a new name (up to 16 characters) (for text
input see page 82).
[RRRRRRRRRRRRRRRRRRRRR]
Save
Now press the display key to confirm the setting.
i
The name of the base station is handset specific, i.e. the base station
receives the name assigned to it from the corresponding handset. The
same base station can have different names on different handsets.
s Repeater Mode
Select the menu item and confirm.
[RRRRRRRRRRRRRRRRRRRRR]
Yes
Press the display key to confirm the prompt.
OK
~ Enter the system PIN (factory setting: 0000) and con-
firm.
[RRRRRRRRRRRRRRRRRRRRR]
Yes
Press the display key to confirm the prompt.
OK