Siemens Gigaset SL400 - Activating the room monitor and entering the destination number

60
Using a handset as a room monitor
Gigaset SL400 / EN for Greek / A31008-M2103-T101-1-8U19 / registr_sett.fm / 08.03.2010
Version 4, 16.09.2005
Activating the room monitor and
entering the destination number
v ¢ É ¢ Room Monitor
¤ You can enter data in the following fields:
Activation:
Select On to activate.
Alarm to:
Select Internal or External.
External number: Select the number
from the directory (press display key
ö)
or enter it manually.
Internal number: Select display key
§Change§ ¢Select handset or Call All to
call all registered handsets
¢ §OK§.
In idle state, the destination number or
the internal destination number is dis-
played.
Sensitivity:
Select noise level sensitivity (Low or
High).
¤ Press §Save§ to save the settings.
When the room monitor function is acti-
vated, the idle display appears as shown
below:
Changing the set destination
number
v ¢ É ¢ Room Monitor
¤ Enter and save number as described in
"Activating the room monitor and enter-
ing the destination number"
(
¢ page 60).
Cancelling/deactivating the room
monitor
Press the end call key a to cancel the call
when the room monitor is activated.
In idle state, press the display key
§OFF§ to
deactivate room monitor mode.
Deactivating the room monitor
remotely
Prerequisites: The phone must support tone
dialling and the room monitor should be set
for an external destination number.
¤ Accept the call from the room monitor
and press keys 9 ;.
The room monitor function will deactivate
after the call ends. There are no further room
monitor calls. The other room monitor set-
tings on the handset (e.g., no ringtone) will
remain activated until you press the display
key
§OFF§ on the handset.
To reactivate the room function with the
same phone number:
¤ Reactivate and save with §Save§
(
¢ page 60).
i V
07:15
INT 1 05 Apr
Á
Room Monitor
0891234567
OFF Options