15
First steps
Gigaset SL785 / GBR / A31008-M2009-L101-2-7619 / starting.fm / 25.03.2009
Version 4, 16.09.2005
Placing the handset in the charging cradle
¤ Insert the mains adapter of the charging cradle into the mains socket.
¤ Place the handset in the charging cradle with its display facing forward.
The handset is registered with the base at the factory. You do not need to com-
plete a registration. If you wish to use your handset with a different base or use
further handsets with your base, you will have to register the handset manually
¢ page 58.
To charge the battery, leave the handset in the charging cradle.
First battery charge and discharge
The correct charge status can only be displayed if the battery is first fully
charged and discharged.
Please note
Only place the handset in the charging cradle that is intended for it.
Please note
u After the first battery charge and discharge, you may place your handset
in the charging cradle after every call.
u Always repeat the charging and discharging procedure if you remove the
battery from the handset and reinsert it.
u The battery may heat up during charging. This is not dangerous.
u After a time, the charge capacity of the battery will decrease for techni-
cal reasons.
¤ Place the handset in the charging cradle
for six hours.
¤ Once the battery is fully
charged, remove the
handset from the charging
cradle and do not put it
back again until the bat-
tery is fully discharged.
6 h
To Next Page
Loading...
