Siemens HB378G0 0 Series User Manual

Shelf supports en
21
‒ To dry the cooking compartment quickly, heat up
the appliance for approx. fiveminutes at 3Dhot
air and 50 °C while the door is open.
17 Shelf supports
To clean the rails and the cooking compartment, or to
replace the rails, you can remove these.
17.1 Detaching the shelf supports
WARNING‒Risk of burns!
The shelf supports get very hot
▶ Never touch the shelf supports when hot.
▶ Always allow the appliance to cool down.
▶ Keep children at a safe distance.
1.
Lift the rail forwards slightly and detach it ⁠.
2.
Pull the whole rail to the front and remove it.
17.2 Attaching the shelf supports
Notes
¡ The rails only fit on the right or left.
¡ For both pull-out rails, ensure that you can pull them
forwards and out.
1.
First, push the rail into the middle of the rear
socket until the rail rests against the cooking
compartment wall, and then push this back ⁠.
2.
Push the rail into the front socket until the rail
also rests against the cooking compartment wall,
and then press this downwards ⁠.
3
4
17.3 Removing the pull-out rail
WARNING‒Risk of burns!
The shelf supports get very hot
▶ Never touch the shelf supports when hot.
▶ Always allow the appliance to cool down.
▶ Keep children at a safe distance.
ATTENTION!
The self-cleaning surfaces in the cooking compartment
may be damaged by detaching and attaching the pull-
out rails.
▶ Detach the rails before detaching or attaching the
pull-out rails.
Notes
¡ Depending on the appliance type, you must change
the basic settings for the telescopic rails for appli-
ances with rails and pull-out rails.
→"Basic settings", Page16
¡ If necessary, you can use pull-out rails on all levels.
1.
Push on the tab marked PUSH behind the rail, and
push the rail to the rear.
2.
Keep the PUSH tab pushed back and swing the
rail outwards ⁠.

Siemens HB378G0 0 Series Specifications

General

Brand	Siemens
Model	HB378G0 0 Series
Category	Oven
Language	English