EasyManua.ls Logo

Siemens HB55MB550B - Oven Door Maintenance; Detaching and Attaching the Oven Door; Cleaning Oven Door Panels

Siemens HB55MB550B
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
The rails fit both the left and right sides. The kinked section
must always be at the bottom.
Detaching and attaching the oven door
For cleaning purposes and to remove the door panels, you can
detach the oven door.
The oven door hinges each have a locking lever. When the
locking levers are closed (figure A), the oven door is secured in
place. It cannot be detached. When the locking levers are open
in order to detach the oven door (Fig. B), the hinges are locked.
They cannot snap shut.
ã=Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. Ensure that the locking levers are always fully closed or,
when detaching the oven door, fully open.
Detaching the door
1.Open the oven door fully.
2.Fold up the two locking levers on the left and right (figure A).
3.Close the oven door as far as the limit stop. With both hands,
grip the door on the left and right-hand sides. Close the door
a little further and pull it out (figure B).
Attaching the door
Reattach the oven door in the reverse sequence to removal.
1.When attaching the oven door, ensure that both hinges are
inserted straight into the opening (figure A).
2.The notch on the hinge must engage on both sides (figure B).
3.Fold back both locking levers (figure C). Close the oven
door.
ã=Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the aftersales service.
Cleaning the door panels
To facilitate cleaning, you can remove the inner door panels
from the appliance door.
ã=Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
ã=Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Remove the door panels from the
Æ main oven and from
the
Ç top oven
Note: Before removing, make a note of which way round the
door panel is fitted, so that it is not refitted the wrong way
round.
1.Unhook the appliance door and lay it on a soft, clean surface
with the front side facing downwards (see section:Removing
and fitting the oven door).
2.Unscrew the cover at the front left and right of the appliance
door and detach it (Fig. A).
3.Lift the door panel and remove it (Fig. B).
%
$
%
$
%
$
%
$
&
$
%

Other manuals for Siemens HB55MB550B

Related product manuals