14
Clean the intermediate panel on the
Æ main oven
1. Unscrew the retainers on the left and right (Fig. C).
2. Unfold the retainers on the left and right.
3. Gently lift the intermediate panel and pull it out forwards.
4. Clean the door panel and intermediate panel with glass
cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Refitting the intermediate panel:
1. Slide in the intermediate panel as far as it will go (Fig. D).
2. Close the retainers on the left and right and screw them tight.
Refitting the door panel:
1. Slide in the door panel all the way.
2. Put the cover back in place and screw it in.
3. Refit the appliance door.
Clean the intermediate panel on the
Ç top oven
1. Press the retainer on the intermediate panel on one side and
unlatch it, using a spatula for instance (Fig. C).
2. Unlatch the other side in the same way and remove the
intermediate panel.
3. Clean the door panel and intermediate panel with glass
cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Refitting the intermediate panel:
1. Place the intermediate panel in the supports on the left and
right (Fig. D).
2. Push the intermediate panel downwards in the retainers.
Refitting the door panel:
1. Slide in the door panel all the way.
2. Put the cover back in place and screw it in.
3. Refit the appliance door.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
Problem Possible cause Remedy/information
The oven does
not work.
The circuit
breaker is
defective.
Look in the fuse box and
check that the circuit
breaker is in working order.
Power cut Check whether the kitchen
light or other kitchen
appliances are working.
0 and three
zeros light up in
the display.
Power cut Reset the clock.
The oven does
not heat up.
There is dust on
the contacts.
Turn the control knobs back
and forth several times.
You wish to
start the
cleaning
system, but
Ÿ©
appears in the
display.
The c4 basic
setting is set to
"no".
Change the c4 basic setting
to selection 1 "yes".
Problem Possible cause Remedy/information
To Next Page
Loading...
