18
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
When removing the inner panels, pay attention to the order in
which the panels are removed. In order to reassemble the
panels in the correct sequence, follow the number which
appears on each panel.
Removal
1. Detach the oven door and lay on a cloth with the handle
facing down.
2. Unscrew the cover at the top of the oven door. To do this,
undo the left and right screws (fig. A).
3. Lift the top panel up and out (fig. B).
4. Unscrew the retaining clips on the right and left and remove
them (fig. C). Remove the middle panel.
5. Pull the lower panel diagonally upwards and out.
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left on both panels.
1. Insert the lower panel diagonally towards the back (fig. A).
2. Insert the centre panel (fig. B).
3. Stick the retaining clips onto the right and left-hand side of
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. C).
4. Insert the uppermost panel diagonally towards the back. The
smooth surface must face outwards.
5. Put the cover back in place and screw it on.
6. Attach the oven door.
Do not use the oven again until the panels have been
correctly fitted.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
ã=Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
&
Problem Possible cause Note/remedy
The appliance does not work. Defective fuse Look in the fuse box and check that the circuit
breaker is in working order.
‹:‹‹ appears in the display.
Power cut Reset the clock.
The oven door cannot be opened.
‹:‹‹
appears in the display. The
H symbol is
displayed.
Power cut during self-cleaning.
Reset the clock. Wait until the
H symbol goes out.
You can now open the oven door.
The oven does not heat up or the type of
heating selected cannot be set.
Type of heating not recognised Make the settings again.
To Next Page
Loading...
