Siemens iQ100 ET611FEB8M - Power Manager Function; Power Manager Operation; Wipe Protection Feature; Activating Wipe Protection

Automatic switch-off en
11
2.
Touch ⁠.
a The ⁠ display for the hotplate lights up. ⁠ ⁠ lights
up on the timer display.
3.
Touch the required presetting on the control panel.
The possible presetting from left to right is 1, 2, 3.....
to 9minutes.
4.
Within the next 10seconds slide your finger along
the control panel until the required cooking time is
reached.
a The cooking time counts down. If you have set a
cooking time for more than one hotplate, the cook-
ing time of the hotplate selected is displayed.
a When the cooking time has elapsed, the hotplate
switches off. A signal sounds and ⁠ ⁠ flashes on the
display for 10seconds. The ⁠ display lights up
brightly.
9 Automatic switch-off
If you do not change the settings of a hotplate for a
long time, automatic switch-off will be activated.
When the hotplate switches off depends on the heat
setting selected (1to 10hours).
The heat to the hotplate is switched off. ⁠ ⁠ and the re-
sidual heat indicator ⁠/ ⁠ flash alternately on the hot-
plate display.
9.1 Continuing cooking after automatic
switch-off
1.
Touch any touch field.
a The display goes out.
2.
Reset.
10 Power manager
The power manager limits the maximum power con-
sumption of the appliance to the value specified on the
rating plate.
When the power limit is reached, the appliance auto-
matically selects the maximum possible heat settings.
The heat setting indicator shows the heat setting and
briefly ⁠.
11 Wipe protection
Wiping over the control panel while the hob is switched
on may alter settings. Your hob has a wipe protection
function to prevent this.
The main switch is excluded from the wipe protection
function. You can switch the hob off at any time.
11.1 Activating wipe protection
▶
Touch ⁠ ⁠.
a A signal sounds.
a The indicator lamp above ⁠ ⁠ lights up.
a The control panel is locked for 30 seconds.