Siemens iQ100 EU61RAGA5B - Ventilation Requirements; Installation Above an Oven; Installation Above a Drawer; Inserting the Hob

en Installation instructions
14
Ventilation
To guarantee that the appliance works correctly, the
hob must be sufficiently ventilated. The ventilation in
the lower section of the appliance requires a sufficient
supply of fresh air. Therefore, if required, adjust the
units for this purpose.
1.
Maintain a minimum clearance between the rear of
the unit and the kitchen wall.
2.
Ensure that an opening at the top of the rear of the
unit is unobstructed.
3.
If the clearance from the back wall of the unit is less
than 20mm, create an opening on the underside.
4.
Do not hermetically seal the lower base.
Note:If the appliance is installed in an island unit or in
another location that is not described here, guarantee
that the hob is ventilated appropriately.
Installation above a drawer
¡ In order to guarantee good ventilation, the clearance
between the surface of the worktop and the upper
area of the drawer must be 65mm.
Installation above an oven
¡ To ensure good ventilation, the clearance between
the top of the worktop and the surface of the oven
front must be 30mm and the minimum clearance
between the oven and hob must be 5mm.
¡ If the clearance between the hob and the oven
needs to be increased, refer to the installation in-
structions for the oven.
16.6 Inserting the hob
1.
Adjust the hob in the front section of the built-in
niche.