NLSet up and connect
The surface must be stable enough to
support the weight of the appliance.
4 Set up and connect
4.1 Scope of delivery
Permissible room temperature
After unpacking, check all parts for
transport damage and the
completeness of the delivery.
In case of complaints, please contact
your dealer or our service →
Page 106
contact on.
The permitted room temperature
depends on the climate class of the
device.
The climate class can be found on the
type plate.
fig.
1
†
6
Climate-
class
Permitted space-
temperature
The delivery consists of:
†Freestanding device
†Equipment and accessories1
†Assembly instructions
†Instructions
†Customer service overview †
Warranty Supplement2
†Energy label
†Information about energy consumption and
sounds
SN
N
ST
t
10 °C…32 °C
16 °C…32 °C
16 °C…38 °C
16 °C…43 °C
The device is fully functional within
the permitted indoor temperature.
If you use a device of the climate class
SN at lower room temperatures,
damage to the device up to a room
temperature of 5 °C can be excluded.
4.2 Criteria for the installation
location
WARNING
Risk of explosion!
If the device is located in a room that is
too small, a flammable gas-air mixture
can form in the event of a leak in the
cooling circuit.
▶ Only set up the device in a room
with a volume of at least 1 m3per 8
g of refrigerant. The amount of
refrigerant is stated on the rating
plate.
fig.
†
Over-and-Under and Side-by-Side
Setup
If you want to install 2 cooling units
above or next to each other, you must
maintain a distance of at least 150
mm between the units. An
arrangement without minimum
distance is possible for certain
appliances. Please contact your dealer
or kitchen installer for this.
1
6
The weight of the device can be up to
120 depending on the model.
4.3 Mounting the device
▶ Install the device in accordance with the
installation instructions supplied.
1
Depending on the device version Not
in all countries
2
92
To Next Page
Loading...
