TroubleshootingNL
Malfunction Cause and Troubleshooting
A warning signal
sounds, the
set temperature
ture (freezer compartment) and
blink.
Various causes are possible.
▶ Press †
aTurn off the alarm.
Freezer door is open.
▶ Close the freezer compartment door.
External vents are covered.
▶ Remove obstacles in front of the external ventilation
openings.
Larger amounts of fresh foodstuffs have been placed in
storage.
▶ Do not exceed the freezing capacity.
→
†Freezing capacity", page 98
Set temperature
ture is not reached.
The freezer compartment door was open too long. There is
a lot of ice on the evaporator (cold generator) in the
NoFrost system.
Fully automatic de-
thawing doesn't work
Lake.
Required:The frozen products are well insulated and
stored in a cool place.
1.Turn off the device.
Page 95
2.Disconnect the device from the power supply.
Unplug the power cord from the socket or switch off
the fuse in the meter box.
3.Contact customer service.
The service number can be found in the enclosed
service overview.
Temperature varies a lot
depending on the setting.
Various causes are possible.
1.Turn off the device.
Page 95
2.Switch the device on again after approx. 5 minutes.
→
Page 95
† If the temperature is too high, check the
temperature again after a few hours.
† If the temperature is too low, check the
temperature again the next day.
Condensation forms
on the surface of the
device and the shelves
in the device.
The water vapor in warm and humid air condenses on
the colder surfaces of the device.
1.Wipe off the water with a soft, dry cloth.
2.Open the device as briefly as possible.
3.Make sure that the device is always closed properly.
103
To Next Page
Loading...
