6
Control panel model 2
Control panel
Setting the fan
Switching on the appliance
■ Press the # button.
The fan starts at setting
ƒ.
■ Press the + or - button to change the fan strength.
Switching off
Press the
# button.
Intensive setting
You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
Press the + button when the fan is at setting
„.
The intensive setting
2‚ is activated. Pressing the + button
again activates the intensive setting
2 ƒ.
After approx. six minutes, the electronics automatically reduce
the fan to a lower setting . If you want to end the intensive
setting before the preset time expires, press the - button until
the required fan setting is reached.
Boost function
The boost function is a short-term maximum power setting
which can be activated in any fan setting.
Press the
& button. After approx. 20 seconds, the fan switches
back to the previously set fan setting.
Fan run-on time
Press the x button.
The fan continues to operate for a further 10 minutes, and
switches off automatically after this time. If the lighting is
switched on, it remains on.
Press the
x button to end the fan run-on time early.
Lighting
The lighting can be switched on and off independently of the
fan.
Press the
A button.
Setting the brightness
Press and hold the
A button until the desired brightness is
reached.
Saturation display
When the metal mesh grease filters or the activated carbon
filter are saturated, a signal sounds for approx. 4 seconds after
the fan is switched off.
In addition, the corresponding symbol appears in the display:
■ Metal mesh grease filter:!
■ Activated carbon filter: "
If you have not yet done so, the metal mesh grease filters
should be cleaned or the activated carbon filter changed now.
For instructions on how to clean the metal mesh grease filters,
please refer to the section Cleaning and maintenance.
While the saturation displays are flashing, they can be reset. To
do this, press the
x button.
Switching over the display for circulating-air mode
For circulating-air mode, the electronic control display must be
switched over accordingly:
■ The extractor hood must be connected and switched off.
■ Press the # and x buttons at the same time until the
™" display for starter sets for circulating-air mode or
the
’" display for CleanAir circulating air modules
lights up.
■ Repeatedly press the button combination to switch the
electronic control display back to exhaust air mode (
!
display).
Audible signal
Switching on the acoustic signal
When the fan is switched off, press the
# and + at the same
time for approx. three seconds. An acknowledgement signal
sounds.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
Explanation
#
Fan on/off
A
Light on/off/dimming
- Reduce the fan settings
+ Increase the fan settings/intensive setting 1, 2
&
Boost function (short-term maximum power)
x
Fan run-on time
To Next Page
Loading...
Need help?
General
