114/301
Siemens Building Technologies Basic Documentation LMV5... CC1P7550en
HVAC Products 7 Display and operating unit AZL5... 13.08.2004
Selection menu «Settings Oil»
Only the data associated with the currently active type of fuel can be parameterized.
S p e c i a l P o s i t i o n s
1)
C u r v e P a r a m e t e r
2)
L o a d L i m i t s
3)
A u x A c t u a t o r
4)
Selection of 1) (HomePositions, PrepurgePositions), 3) and 4) leads to standard pa-
rameter settings of the parameters specified.
Selection of 2) leads to:
C u r v e S e t t i n g s
1)
O p e r a t i o n M o d e
2)
Selection of 2) leads to standard parameter settings of the operating mode (modulating
or multistage).
Selection of 1) leads to curve setting, modulating (refer to gas) or curve setting, multi-
stage, depending on the parameterized operating mode.
Setting modulating ratio control
Refer to selection menu «Settings Gas»
To Next Page
Loading...
