Siemens MASS 2100 - Page 285

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
2.3.1.7 Fail-safe behaviour Select reaction of the totalizer
function in case of unreliable
process flow value.
Run
● Run
● Hold
● Memory
User
2.3.1.8 Reset Reset totalizer 1 to zero
● Cancel
● Ok
User
2.3.1.9 Preset Reset totalizer 1 to selected pre‐
set value
● Cancel
● Ok
User
2.3.1.10 Alarm and warning limits
2.3.1.10.11) Upper alarm limit Set upper alarm limit. Alarm is
triggered if totalizer 1 value is
above the limit.
[kg] User
2.3.1.10.21) Upper warning limit Set upper warning limit. Waning
is triggered if totalizer 1 value is
above the limit.
[kg] User
2.3.1.10.31) Lower warning limit Set lower warning limit. Warning
is triggered if totalizer 1 value is
above the limit.
[kg] User
2.3.1.10.4 1) Lower alarm limit Set lower alarm limit. Alarm is
triggered if totalizer 1 value is
above the limit.
[kg] User
2.3.1.10.5 1) Hysteresis Sets the hysteresis for alarm
and warning limits. The hystere‐
sis is the distance between the
limits for activation and deactiva‐
tion of an alarm/warning.
0
[kg]
User
2.3.1.10.12) Upper alarm limit Set upper alarm limit. Alarm is
triggered if totalizer 1 value is
above the limit.
[m3] User
2.3.1.10.22) Upper warning limit Set upper warning limit. Warning
is triggered if totalizer 1 value is
above the limit.
[m3] User
2.3.1.10.32) Lower warning limit Set lower warning limit. Warning
is triggered if totalizer 1 value is
above the limit.
[m3] User
2.3.1.10.4 2) Lower alarm limit Set lower alarm limit. Alarm is
triggered if totalizer 1 value is
above the limit.
[m3] User
2.3.1.10.5 2) Hysteresis Enter the hysteresis to avoid un‐
wanted rapid switching.
0
[m3]
User
2.3.1.10.3) Upper alarm limit Set upper alarm limit. Alarm is
triggered if totalizer 1 value is
above the limit.
[normal m3] User
2.3.1.10.23) Upper warning limit Set upper warning limit. Warning
is triggered if totalizer 1 value is
above the limit.
[normal m3] User
2.3.1.10.33) Lower warning limit Set lower warning limit. Warning
is triggered if totalizer 1 value is
above the limit.
[normal m3] User
Default settings
B.4 Totalizer
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 285