Siemens MASTERDRIVES MC 1FK7 - Page 100

Gearboxes
Helical and angled gearboxes
1FK7 Synchronous Motors
5-10 Configuration Manual (PFK7), 10/2005 Edition, 6SN1197-0AD06-0BP1
5.2.2.2 Order codes required
Order No. geared motor
Order codes
1FK7 . . . – . . . . . – . . . . – Z
1. Order code
Gearbox Type
• Bevel gearbox B
• Offset gear C
• Helical gear D
• Worm gearbox E
2. Order code
Type
• Foot-mounted version
1
) G 1
• Tapped hole group G 2
• Flange (circular) G 3
• Foot-mounted and flange (circular)
1
) G 5
• Foot-mounted and tapped hole group
1
) G 6
Gearbox shaft end
For helical gearboxes: For offset shaft gearboxes: For bevel and worm gearboxes:
Solid shaft with key • Solid shaft with key, gearbox side 5 • Solid shaft with key, gearbox side 4 1
• Hollow shaft with keyway • Hollow shaft with keyway, insertion gearbox side 4 3
• Hollow shaft with tensioning element,
shrink disk, side 6,
insertion gearbox side 5
• Hollow shaft with tensioning element,
shrink disk, side 4,
insertion gearbox side 3
4
• Solid shaft with key, gearbox side 3 5
• Hollow shaft with keyway, insertion gearbox side 3 7
• Hollow shaft with tensioning element,
shrink disk, side 3,
insertion gearbox side 4
8
3. Order code
Type of construction Mounting position
Helical gearbox: Offset shaft, bevel and worm gearboxes:
• IM B 3 / IM B 5 / IM B 14 / IM B 34 / IM B 35 •EL 1 H 1
– •EL 2 H 2
•IM B 8 •EL 3 H 3
• IM B 6 / IM B 7 •EL 4 H 4
•IM V 1 •EL 5 H 5
• IM V 3 / IM V 6 / IM V 19 •EL 6 H 6
•IM V 5 – H 7
•IM V 18 – H 8
Connector mounting position
• Connector position: Gearbox side 2, on top 1
• Connector position: Gearbox side 4, on right 2
• Connector position: Gearbox side 1, bottom 3
• Connector position: Gearbox side 3, left 4
1) The mounting feet are always on gearbox side 1.