Installing MK8000 Software
22
Building Technologies 048_DMS_MK8000_ICC_MP4.10_A6V10062407_a_en.doc
Fire Safety & Security Products 06.2007
4 Installing MK8000 Software
MK8000 and MM8000 solutions
The MK8000 OPC server MP4.10 can be used both as an independent OPC
server (as in previous versions) or run as a component of a larger MM8000 man-
agement system. This document discusses the installation procedure of the first of
the two options, whereas the MM8000 ICC manual (doc.no.A6V10062413) should
be referred to about the MM8000 product installation.
MK8000 architectures
MK8000 OPC server may be set up as a single station or as a distributed system.
On a single station PC, you need to install the MK8000 Stand-Alone software, in-
cluding the OPC server and the related configuration tools.
The same Stand-Alone software has to be installed on the main station of a distrib-
uted system, which can also include more stations, equipped with either MK8000
communication FEP (Front End Processor) software or OPC Client applications.
In the Stand-Alone station, the MK8000 requires some additional software to be al-
ready installed (pre-requisite); namely: MSDE 2000 (or SQL Express 2005 and
SQL 2005 Backward Compatibility), SQLXML 3.0, NET framework V1.1.and NET
framework V2.0. This software is provided free of charge on the DMS8000 CD.
In order to run and perform, the MK8000 software requires a hardware key (don-
gle) and a related Product Activation Key (PAK), i.e. a 16-character code.
Distributed systems may include a redundant solution (see 3.2.1.1).
To Next Page